-40%
Barbed 1/4

Barbed 1/4" Tubing Cross for Drip Irrigation Systems-50 pack

$ 6.83

Availability: 207 in stock
  • MPN: 1403
  • UPC: 818564010720
  • Brand: Drip Depot
  • All returns accepted: Returns Accepted
  • Type: Drip Irrigation - Crosses
  • Return shipping will be paid by: Buyer
  • Condition: New
  • Item must be returned within: 30 Days
  • Refund will be given as: Money Back

    Description

    Use a Barbed Tubing Cross when you need to create a junction splitting into four directions with the same size poly tubing.
    Quality barbed fittings provide high retention in low-pressure poly tubing for long-term reliability of connections. The acetal fittings can be confidently installed without clamps when matched with our quality low-pressure poly tubing with corresponding dimensions. See note below on gray PVC fittings.
    Features:
    Sharp-edged barbs create leak-proof seal
    Increased strength and superior quality
    Heat, chemical and wear-resistant
    UV stabilized materials for long life
    Special Note:
    1/4" barbed fittings have the unique ability to be "snapped" into larger tubing after punching a hole into the side of the larger tubing with any of our 1/4" punch tools. This creates a water-tight seal and allows you to "tee-off" of larger diameter tubing using only 1/4" fittings and a hole punch.
    Please Note:
    Gray PVC insert fittings are made of the same substances as schedule 40 and schedule 80 PVC are made of. This means a durable long lasting fitting. Insert fittings are normally used with flexible pipe, hose or tubing. Simply slip the barbed insert tip all the way into the end of the flexible pipe, hose, or tubing. Multiple sharp barbs provide a tight grip on the flexible materials to create the seal. It is recommended to clamp over the barbed fittings to provide a reliable leak-proof seal. Proper clamping technique is to place the clamp directly over the barb area and tighten. For additional size specifications see the Spec sheet linked to item page above.
    Fitting Size
    Acceptable Inside Tubing Diameter
    Fitting Use
    Max Operating Pressure
    1/8"
    .125"
    To connect sections of 1/8" tubing or to connect 1/8" tubing to mainline tubing
    Up to 30 PSI
    1/4"
    .170"
    To connect sections of 1/4" tubing or to connect 1/4" tubing to mainline tubing
    Up to 30 PSI
    1/2"
    .570" to .620"
    To connect sections of 1/2" poly tubing together
    Up to 30 PSI
    3/4"
    .805" to .820"
    To connect sections of 3/4" poly tubing together
    Up to 40 PSI
    1"
    1.06"
    To connect sections of 1" poly tubing together
    up to 40 PSI