ROTARY A/C SWITCH 3 SPD BLOWER SWITCH W/ 'SHORT' HARNESS & PLUG, 'FAN' KNOB USA

Description

NEW AIR CONDITIONING Rotary 3 Speed Blower Switch
With 'FAN' Knob,
Harness and Plug..Has 5 Spade Terminals And  A 1/4" 'D' Shaft For The Knob.Threaded Shaft Length Approx. 3/8"
(Body is Approx. 1" X 1" Square
, Threaded Sh
aft Diameter Is 7/16"
)
SWITCH IS INDAK BRAND, MADE IN USA!!
Indak is Leading USA Supplier For MANY OEMs, General Motors,Ford,Chrysler and Others Switches!!
(Plug Has
SHORT
,
4" Multi Colored Wire 'Pigtail' For Ease Of Installation.
Yellow
is 'Medium' Speed,
Green
is 'Low',
Orange
is 'High',
Red
is 'Power or Hot, Blue is 'Clutch/Compressor')
(Knob has 'FAN' Face)
Has Off/ Low/Med/High Positions,
12 Volt
, 25 Amp. Rating
The 'H' , 'M' and 'L' terminals
are  for fan speed leads.
.
The 'B' terminal is the power 'in' terminal, while the 'C' terminal is for the clutch,thermostat, trinary or binary switch depending on application. There is
NOT
a ground terminal on the switch. The motor and /or switches are normally internally or externally grounded.
*NOTE* THIS
DOES NOT
MAKE YOUR 1 SPEED MOTOR A 3 SPEED !! THIS IS FOR MOTORS THAT ARE ALREADY 3
SPEED
!!!
THESE ARE FOUND ON MANY UNDER THE DASH A/C UNITS .
Replaces :
Four Seasons
35702
MEI
1151
Honda
00091-31511
Red Dot
71R1150 / RD3646
Freightliner
INM2G754A
Kenworth 71R1150
Mack 4428-2T754A
Delco
15-50180
Everco
H755
Santech  MT1355 / MT1345